This version of the Brick Wall line of surge suppressor/line filters is a panel-mounted, 20amp unit. Allowing protection for an entire 20 amp circuit, this unit's applications range from fire alarm and security system sub-panels to dedicated computer room and home theater circuits.
|Outlets Available||None, this unit has a terminal strip for connection.|
|Load Ratings||20A at 120 volts, single phase, 50-60 Hz; full load regulation 1%.|
|Endurance Test||1,000 surges of 6,000 volts, 3,000 amperes, SRV <400 volts, no failures, L-N (ground wire protection) mode, U.S. Gov't. Mode 1.|
|Limiters||Series surge reactor current limiter; cascaded, auto-tracking dual polarity voltage limiters; dual pulse inverters. Parameters optimized for switch-mode power supply protection.|
|Clamping Voltage Onset||172 volts nominal; 2 volts above peak line voltage (auto-tracking).|
|EMI/RFI Filter Response||(bi-directional, wave tracking): With 50 ohm Rg load: 3db at 5kHz; 26dB at 100kHz; 38dB at 300kHz.|
|Let-Through Slew Rate||5,000 volt/microsecond disturbance reduced to 28v/microsecond within AC power wave envelope, and less than 10v/microsecond outside the power wave envelope.|
|Maximum Applied Surge Pulse Joule Rating||Unlimited rating (due to surge current limiting) (8x20microsecond).|
|Maximum Applied Surge Pulse Voltage||6,000 volts (1.2 x 50 microseconds) (Industry Standard rating).|
|Maximum Applied Surge Pulse Current||>100,000 amperes (unlimited due to current limiting) (8 x 20 microseconds).|
|Endurance, C62.41-1991 (formerly IEEE 587) Category B3 (C1) pulses||2kv>100,000; 4kv>10,000; 6kv>1,000 (NRTL verified).|
|Dimensions||10" H x 10" W x 4" D|
Call us toll-free at (800) 528-0313
Or order right here on the site!